Your Daily Shave Routine

[stagger]

1. Place shaving bowl in sink
2. Fill sink 1/2 full with HOT water
3. Wet washcloth in sink and apply to face for 2 minutes
4. Remove shave bowl, make lather, apply to face
5. 3 pass shave, WTG, XTG,ATG
6. Rinse and apply shave balm, then cologne

_________________
Regards,
Mark - TABAC and TOBS Rose

[ThePossum]

• Place my brush of the day in hot water in shave mug in sink filled with hot water.
  
• Take shower and prep face with hot towel for about a minute.
  
• After shower, make lather and apply to face. Do three passes, WTG, XTG, ATG, followed by a buffing pass if needed. No rinse between passes.
  
• Apply Thayer's as an astringent and then one of my many A/S or ASB.
  
• Apply an EDT if I am going out right away.
  
• Clean up the razor, brush, mug and get things ready for my next shave. Includes a hand strop of my DE & SE blades and putting the blade in the next razor in my rotation.
  

_________________
Bryce

My Shave Stuff
The Original Safety Too - An SE Razor Forum

[Straight Arrow]

I always shave before the shower.

1. Run water until medium hot
2. Put rubber stopper in drain
3. Place brush in sink
4. Splash water on face as sink fills
5. Shake brush two or three times
6. Swirl brush on soap
7. Build lather on face
8. One pass WTG
9. Some cleanup strokes on chin and jawline
10. Rinse razor and brush
11. Get into shower

_________________
Rich

[Lou]

I shower at night.

15-20 minutes after I get up, I wash my face and hold a hot facecloth to my beard for a few minutes.

I partially fill my sink with hot water, soak my brush for a bit, load the brush with soap, and face lather.

I do one WTG pass, then an XTG pass on my mustache and chin.

I rinse off my face with cold water, soak the face cloth with cold water, add a squirt of witch hazel, and hold it to my face for about 10 seconds. I rinse again with cold water.

I apply an AS balm, which is the last step in the shave portion of my morning routine.